1977 Bayfield 32

This Bayfield 32 has been extensively upgraded and is turn-key and ready to go cruising. This well-respected and capable cruiser is priced for a quick sale and when you see the upgrades and how well cared for this vessel is it's certainly one of the best deals on the coast.

 Some of the recent upgrades include sails, rigging, hull-refinished with new barrier coat and bottom paint, Rocna anchor, Lewmar windlass, professionally serviced Yanmar engine with 850 hours since the rebuild, aluminum dodger and new RIB and outboard.

 This is a perfect boat for a couple or individual wanting to explore the Pacific Northwest.

Accommodation

The Bayfield 32 has a classic interior with a V-Berth forward with storage below. The head is immediately aft and has hot and cold running water and a marine toilet with a holding tank.

The salon has a large C-shaped dinette to starboard that converts into a large double berth. On the port side is a full-length settee.

Aft of the salon is the galley to starboard with deep sinks, propane stove, and oven as well as refrigerator unit. To port is a navigation station and a quarter berth aft under the cockpit.

The interior upholstery has been updated and all the wood has been re-finished including new teak and holly flooring. It looks great inside.

• Newer upholstery and cushions

• New teak and holly laminate sole

• ESPAR forced air heater

• Caribbean Dickinson 2-burner propane stove with oven

• Stainless steel sink

• Pressurized fresh water with 16-gallon tank

• Enclosed head with toilet (15-gallon holding tank)

• Pressure sink & shower

• Newer dinette folding table

• Force 10 BBQ

Electronics and Electrical

Has the basics for cruising the coast and almost everything is less than 5 years old.

• EVO 100 Raymarine autopilot with self-calibrating rate compass

• Hawkeye depth sounder

• Lowrance VHF Radio with DSC

• CP175c Standard Horizon plotter with charts for the Pacific Coast, Mexico, and the Caribbean.

• 2 X 100-watt solar panels and 10 amp charge controller.

• ProMariner Pro Sport 12 battery charger

• LED lighting

• 1500 watt Eliminator inverter

• 2 X 12 Volt HD Series 27 House Batteries

• 1 X 12 Volt HD Battery 24 Starter Battery

Sails and Rigging

Can be run as a cutter or sloop-rigged boat with roller furling on the foresail. New sails were made in 2018 with limited use. Standing rigging was upgraded in 2015 and was inspected and re-tuned in 2023. The mainsheet traveler has been moved on top of the aluminum dodger to free up room in the cockpit. All lines are led aft making this a fantastic boat for single handling.

• Oversized standing rigging was upgraded in 2015.

• Sail pack from Leach McBride 2018

• Leitch & McBride Full battened main and genoa 2018

• Asymmetric spinnaker, storm sail, and spare genoa.

Ground Tackle

• Rocna 15 anchor

• Lewmar Pro 1000 anchor windlass (with cockpit and deck switches)

• 100 feet of 5/16 chain with 200 feet of ½” nylon rode

• Stainless steel bow roller

• Spare new Danforth 25 lb and nylon rode.

Machinery

The engine was rebuilt and has 850 hrs since the rebuild. It also went through a full assessment at Stones Marina in 2023 and every recommendation was completed. This included a compression test and a new alternator was installed.

• Yanmar 3GMD 20 hp

• Kanzaki KM3-A marine gear

• PSS, dripless shaft seal

• Morse dual levers at the helm

• 16 gallon fuel tank

Additional Items

• A new rigid hull inflatable tender was purchased in 2023 as well as a new outboard.

• Manual pump and automatic electric bilge pumps

• Stainless folding safety ladder

• LED navigation lights

• LED spreader/deck light

   

  Upgrades & Maintenance since 2020

   

• New high-pressure oil line

• New water pump

• The exhaust system completely replaced including the stainless mixing elbow

• Fuel injectors cleaned

• New spare starter

• New teak/holly veneer marine plywood floor

• New folding table in the salon

• New teak dish/spice rack

• New teak cockpit table

• New bimini extension for dodger

• New hot water heater

• New curtains

• New asymmetrical spinnaker

• New storm jib

• Hull sanded down to gel coat with new barrier cote and multiple coats of Micron CSC